Trucco per piegare plasticard

Rispondi
Avatar utente
Redones
Presentato
Messaggi: 2862
Iscritto il: lun 12 dic 2016, 22:24

GD Fellow

Trucco per piegare plasticard

#1

Messaggio da Redones » dom 8 gen 2017, 13:17

Da Mechdesigns

You will need three pieces of tealight candle.

Immagine

You will also need a glass tealight candle holder.

Immagine

Light two of the candles to melt it and remove it from the container.

Immagine

Once melted remove the candle.

Immagine

You will need two of this container.

Immagine

For the first one cut a rectangular shape at the middle part of the bottom. This open space is where you will put the part of the styrene that you will bend

Immagine

On the second container cut the bottom part and drill holes on the sides.

Immagine

These holes will help to allow air to flow inside so that the candle will not get diffused.

Immagine

Now it's time to put together the materials. First put the container with holes.

Immagine

Then put the other container at the top facing down.

Immagine

put the part of the styrene in the middle and let it stay for 3-5 seconds. It will soften the styrene due to the heat seeping out of the open area but not hot enough to melt it all through out like heating it directly.

Immagine

bend the styrene to the angle you need and hold it in place until the styrene hardened again.

Note that once you heated polystyrene plastic, it will hardened it and bending it after you heated it will cause it to break.

Immagine


ImmagineImmagine

Rispondi

Torna a “Custom”